Click on the boxes next to the two accepted methods of replacing the atmosphere in cargo tanks:
You have just completed loading 450 tonnes of Caustic Soda to two tanks on your vessel and will be trading to NW Europe with an ETA Rotterdam of December 6th. What would be a prudent operational measure to carry out?
Any operation involving nitrogen must be governed by an appreciation of:
Tank capacity measured against nitrogen supply rate.
Liquid flow in versus liquid flow out.
Rate of nitrogen supply measured against cargo pump capacity.
Rate of nitrogen flow in versus capacity of venting system out.
If a vessel has just loaded a solidifying or high-viscosity cargo, what procedure may routinely need to be implented?
Two of the terms below indicate methods by which a pipeline may be cleared to a ship. Which are they?
Which regulations indicate the requirements for the control of tank atmospheres in compartments containing chemicals?
The ICS Tanker Safety Guide (Chemicals).
What additional process can be applied to de-humidified air to make it more efficient in drying tanks?
What is “dew point”?
The temperature at which a gas is saturated with respect to a condensable component.
The temperature at which a condensable component is saturated with respect to a gas.
The temperature at which a saturated gas becomes in ambient.
The temperature at which dry-ice melts in acetone.
The illustration shows a compressed air supply rigged to blow a pipeline. Click on the correct sequence to ensure no back-flow of product occurs when commencing blowing the line:
Supply valve / drain-cock / manifold valve.
Supply valve / manifold valve / drain-cock.
Drain-cock / manifold valve / supply valve.
Manifold valve / drain-cock / supply valve.
What colour identification strip is commonly used to mark nitrogen lines?
Powder blue with a 10 cm (4″) green stripe.
Click on the boxes to indicate items of information that must appear on a Certificate of Inhibitor:
Indicate two types of liquid pad, which may be encountered in the carriage of certain specific liquid chemicals:
You are discharging vegetable oils to rail cars on shore. What additional precautions is it prudent to adopt?
Keeping a fresh water supply adjacent to the shore gantry to wash down any spillage.
Positioning extra personnel on the ship’s manifold to ensure continuous communication.
Blowing down of ship’s lines in the event of a protracted delay between groups of rail cars.
Drawing up written procedures to cover the discharge and have them signed by a shore representative prior to commencement of discharge.
When purging a cargo tank with nitrogen, the critical relationship is:
Tank capacity measured against nitrogen supply rate.
Liquid flow in versus liquid flow out.
Rate of nitrogen supply measured against cargo pump capacity.
Rate of nitrogen flow in versus capacity of venting system out.
De-humidified air can be made more efficient for drying tanks by:
By injecting nitrogen into the shore pipeline during the loading process, which of the following advantages may be obtained?
The requirement to pre-inert is much reduced.
The need to pre-inert is avoided entirely.
The need to monitor nitrogen levels after loading is eliminated.
Loading can take place at a higher rate.
Which of the following items must a vessel legally have on board prior to loading a cargo of Styrene Monomer?
A Certificate of Analysis.
A Certificate of Inhibitor.
Which International Chamber of Shipping publication contains specific details on the use of nitrogen on chemical tankers?
The Nitrogen Handling Manual.
The Tanker Safety Guide – Chemicals.
The safest time to add nitrogen to a cargo tank is:
Immediately after loading.
As the cargo is being loaded.
As the vessel approaches the discharge port.
The two parts of the rotating bed in a de-humidifier unit are referred to as:
What term is applied to the discharge of rail cars by the application nitrogen?
Under normal circumstances, gas moves through a pipeline more easily than liquid. True or False?
You are to receive cargo from rail cars. Which of the following risks should you be specifically aware of?
Once the maximum operating pressure is achieved in the rail car, its safety valves will lift.
As a tank car finishes, nitrogen may pass into the ship’s tanks, resulting in an overflow or structural damage if not controlled.
As a tank car commences, the ship’s tank will be over-pressured and structural damage will result.
The pressure build-up in the ship’s tank may result in a reduced discharge rate from the rail cars.
Click on the boxes next to the two main reasons behind the use of nitrogen on chemical tankers:
The storage temperature of liquid nitrogen is approximately:
You have just loaded a cargo of Toluene. What particular hazard must you be aware of in terms of line clearing?
Toluene has a high melting point.
Toluene is a static accumulator.
Toluene needs to be blanketed.
Toluene is a high viscosity cargo.
Putrefaction is a term applied to which of the following terms?
The dissolution of Caustic Soda.
The blanketing of low-flash cargoes.
The decomposition of vegetable oils.
The pyrolyzation of light refraction oils.
A supply through a 100 mm (4″) line, delivered at 5,2 bar (75 psi), can introduce which of the following volumes of nitrogen?
What should be reached before commencing any operation involving nitrogen?
Agreement on completion time.
Agreement on who will operate the shore valves.
Joint calculation of the minimum nitrogen quantity required.
The full agreement on and understanding of all aspects of the operation by all parties involved.
Click on the boxes to indicate the possible purposes of additives:
To obtain around 2 % oxygen content in a cargo tank by the dilution method, approximately how many volume changes of pure nitrogen will need to be injected:
Symptoms of skin damage resulting from contact with liquid nitrogen may resemble which of the following conditions?
Which method of atmosphere replacement is generally practised on chemical tankers?
If during loading of liquid nitrogen, drops of the liquid are allowed to contact the steel deck, which of the following risks is created?
A toxic atmosphere will develop.
Localised steel fracture.
Localised steel delamination.
Extensive steel distortion.
Identify the correct relationship for rail car safety and operating settings on US tanks cars from the list below:
Safety valve: 12 bar, maximum operating pressure: 8 bar.
Safety valve: 5,2 bar, maximum operating pressure: 4,1 bar.
Safety valve: 4,1 bar, maximum operating pressure: 5,2 bar.
Safety valve: 8 bar, maximum operating pressure: 5 bar.
Which of the following items must a vessel legally have on board prior to loading a cargo of Methyl Acrylate?
A Certificate of Analysis.
A Certificate of Inhibitor.
What possible source of contamination might be encountered if steam is used during tank cleaning?
Boiler treatment chemicals.
Dew point is defined by which of the following statements?
The temperature at which a gas is saturated with respect to a condensable component.
The temperature at which a condensable component is saturated with respect to a gas.
The temperature at which a saturated gas becomes in ambient.
The temperature at which dry-ice begins to melt in acetone.
The MARPOL 73/78 regulations require chemical tankers of 30 000 dwt and over to inert all cargo tanks containing petroleum products with a flash point of 60 °C and less. True or False?
When maintaining a nitrogen pad on passage, a daily application will involve:
Low pressure and high volume.
High pressure and high volume.
Low pressure and low volume.
High pressure and high volume.
A tank structure may fail at as little as which of the following over-pressures?
What must the responsible officer ensure is available in a tank prior to a line clearing operation?
Adequate pressure to ensure good flow in the vapour return system.
Adequate space to accommodate the remaining product without exceeding maximum filling limits.
Independent portable ullaging equipment.
Oil tankers use an inert atmosphere specifically to prevent:
Corrosion of the tank surfaces.
Fire or explosion in a tank containing a hydrocarbon gas/air mixture.
Loss of cargo quantity during a loaded passage.
Reduction of cargo quality during a loaded passage.
In larger ports, nitrogen is commonly supplied to terminals by:
Click in the boxes next to mediums commonly used in drying cargo tanks:
Inert gases create which of the following:
An oxygen deficient atmosphere.
An oxygen enhanced atmosphere.
An oxygen rich atmosphere.
An oxygen compliant atmosphere.
Humid atmospheric conditions may cause a cargo tank to:
Unconsciousness resulting from entering into an inerted space without breathing apparatus can occur earliest in which of the following times?
Which of the following items are required to be indicated on a Certificate of Inhibitor?
What is the term applied to the technique of recycling the exhaust atmosphere during a purging operation, using it to commence purging down in a second compartment?
Click on the boxes to indicate the main types of nitrogen system, which may be encountered aboard a chemical tanker:
Should unbroken blisters resulting from a steam burn be left intact?
Purging is defined by which of the following statements?
The filling of a cargo tank and associated piping systems, or the spaces surrounding a cargo tank, with a saturated gas or vapour which will not support condensation and which will not react specifically with the cargo, and maintaining that condition.
The filling of a cargo tank and associated piping systems, or the spaces surrounding a cargo tank, with a gas or vapour, which will not support combustion and which will not react with the cargo and maintaining that condition.
Click on the boxes next to the terms, which describe the two methods of line clearing of a pipeline to a ship:
Which of the following statements is an accepted definition of purging?
The filling of a cargo tank and associated piping systems, or the spaces surrounding a cargo tank, with a saturated gas or latent vapour, which will not induce hydrolysis, and maintaining that condition.
The filling of a cargo tank and associated piping systems, or the spaces surrounding a cargo tank, with a gas or vapour, which will not support combustion and which will not react with the cargo, and maintaining that condition.
The gas-freeing of a cargo tank, to a level at which the hydrogen sulphide content, as measured, is less than 35 ppm.
Click on the boxes next the correct reasons for cleaning a hose prior to disconnection:
The term “Asphyxiates” is applied to:
All oxygen dependent inhibitors.
Inerting techniques on chemical tankers.
All cargoes with a high evaporation rate.
Entering unprotected into an inerted space can lead to unconsciousness in as little as:
During line clearing operations, which particular area is it critical, that ship’s personnel man throughout?
Adjacent to the VHF radio.
You are the officer on watch and are about to undertake a line clearing operation from shore. What must you ensure is available in the required tank?
Independent portable ullaging equipment.
Adequate pressure to ensure good flow in the vapour return system.
Adequate space to accommodate the remaining product without exceeding maximum filling limits.
Which of the following cargoes is an example of one loaded in a tank, where the surrounding empty voids and ballast tanks will also be inerted?
If a chemical tanker has tank-cleaning machines with a nozzle throughput of more than 17,5 cubic meters per hour, is it subject to inerting requirements in cargo tanks containing low-flash products?
Which of the following chemicals has an inhibitor added for marine transportation?
Under normal circumstances, which moves through a pipeline more easily?
Allowing for regional variations regular nitrogen cylinders are commonly:
70-75 litres capacity at 125-130 bar pressure.
200 litres at 50 bar pressure.
100 litres capacity at 175-200 bar pressure.
40-50 litres capacity at 180-200 bar pressure.
Click on the boxes to indicate which of the following are among the items indicated on the tank entry permit?
Why is a hose cleared prior to disconnection? Click on the boxes next to the relevant reasons:
Regular nitrogen cylinders are:
50-60 litres capacity at 90-100 bar pressure.
100-120 litres capacity at 200-220 bar pressure.
40-50 litres capacity at 180-200 bar pressure.
180-200 litres capacity at 45-50 bar pressure.
Which of the following is a true statement?
Extended blowing of a cargo hose will lead to the destabilisation of an additive.
Polymerization will result from prolonged blowing of a cargo hose with air.
The specification of a colour sensitive cargo will be adversely affected if the cargo hose is blown with nitrogen after discharge.
Prolonged blowing of the cargo hose used for loading a cargo containing an oxygen-dependant additive with nitrogen may lead to a significant drop in the efficiency of that additive.
The term applied to the decomposition of vegetable oils is:
Approximately how long will it take to deliver 5 000 cubic meters of nitrogen gas through a 100 mm (4″) pipeline at 5,2 bar (75 psi)?
The exhaust gas from a nitrogen generator exhaust outlet can typically contain which of the following oxygen levels?
Which regulations detail the requirements for the control of tank atmospheres in compartments containing chemicals?
The ICS Tanker Safety Guide (Chemicals).
Nitrogen is frequently used in drying cargo tanks, but which other medium from the list below is commonly utilised in this task?
If a cargo additive is oxygen dependent and prolonged blowing of a cargo hose with nitrogen takes place, what may happen?
The efficiency of the additive will be increased.
The efficiency of the additive may be significantly reduced.
Immediate polymerization will occur around the cargo pump.
The colour of the cargo will be affected.
The traditional manual dew point meter employs which of the following substances?
Click on the boxes to indicate the two types of shipboard nitrogen generator:
The maintenance of a nitrogen pad is also sometimes referred to as:
If a ship enters a channel, where the water is relatively cold and still, what may occur in the cargo tanks?
Desorption in the upper area of the wing tanks.
Evaporation on the bulkheads.
Sweating of the bulkheads.
Inert gas drawn from an in-line unit in the main or auxiliary boiler exhaust, cannot normally be used in chemical tanker operations, because:
The gas will be above the LEL.
SOLAS requires this type of generator to be fitted only on oil tankers.
It will be laden with hydrocarbons and soot particles, that would have a significant negative impact on the cargo quality.
MARPOL Annex II prohibits tank washing direct to sea after inerting with such gases.