The test consists of 80 random questions.
Total questions on this topic: 198
What is the acronym FR 01?
To receive distress alerting and MSI via an Inmarsat-C set vessels must have:
A radio officer on board.
MF/HF radio telex scanner with printer.
Suitable for 518 kHz NAVTEX receiver.
What is the two letter signal, to be used by flags, radiotelephony or radiotelegraphy, meaning “Calling All Ships”?
You receive a distress alert on HF Radio. What should you do?
Wait three minutes and if no acknowledgement is heard from a coast station you should relay the alert.
No response is necessary providing the vessel is more than 24 hours away.
Relay the message immediately on 2 182 kHz.
The position of a 406 MHz Cospas-Sarsat EPIRB is:
Passed on by the EPIRB to the satellite.
Measured by the “dopler” shift in the signals.
Determined by satellites by means of directional aerials.
The word CHANNEL is spelled conform the international phonetic alphabet:
Charlie, Hotel, Able, November, November, Echo, Liverpool.
Cornelies, Hotel, Alfa, November, November, Echo, Lima.
Charlie, Hotel, Alfa, November, November, Echo, Lima.
Cornelies, Hotel, Apple, November, November, Echo, Land.
If a ship according to the rules of GMDSS is equipped with an MF/HF radio set a DSC listening watch must be kept on:
2 187,5 kHz, 8 414,5 kHz and for instance 12 577,0 kHz.
All DSC distress frequencies.
2 182 kHz and channel 70.
8 414,5 kHz and on at least one of the following DSC frequencies: 4 207,5 kHz, 6 312,0 kHz, 12 577,0 kHz or 16 804,5 kHz.
The number of oscillations of a wave per seconds is called:
Is it necessary to state the accounting code of the vessel in fully automated radio telex-traffic with a coast-station?
No, because the AAIC is included in the radio telex-identification.
No, when AAIC is unknown, it will be asked for.
It depend upon your location.
A battery of 24 Volt supplies during 10 hours a current of 6 ampere. What is the capacity supplied?
The ship-shore HF-telephone-channel 2 228 consists of the frequencies 22 081,0 kHz and 22 777,0 kHz. In case of manual operation, one should tune the receiver on:
The common receiving frequency for the 22 MHz band.
What statement is correct with frequency modulation?
The amplitude fluctuating an LF-rhythm.
Frequency modulation is often applied in the maritime VHF-range (band).
The amplitude remain constant.
The frequency is constant.
For how long time should a “SARSAT COSPAS” epirb be able to operate on its batteries?
By frequency is meant:
Time lapse of vibrations.
Number of vibrations per unit of time.
Long distance communication in the HF-bands depends on:
At the entrance to the space where batteries are stored on board the following notice must be fitted:
No entry with naked light and/or flame.
The sensitivity of a communication receiver can be adjusted with:
The effect of reflection of the radio waves in the ionosphere on the range depends on:
The correct adjustment of the button band width.
The amount of ionisation.
The correct adjustment of the clarifier.
The correct adjustment of the dimmer.
One can check the functioning of the SART by:
Activating the SART and checking the effect on the radar screen.
Removing it from the holder and turning the SART upside down.
Lowering SART in to the sea.
Activating it by extracting the antenna.
A DSC-notice should be sent on VHF-channel:
What HF-band is generally suitable for long distance transmission if one of two stations is Located in twilight?
A distress-call, onboard via RCC, may only be given Receipt if:
OSC from the RCC concerned invites the vessels.
The OOW deems it necessary.
With maintenance of batteries it is of primary importance that:
The space where the batteries are stored is properly ventilated.
There is proper relative humidity in the space where the batteries are stored.
There is an absolute free access to the battery space.
If a coast-station doesn’t answer a call on VHF working channel or doesn’t send a reply signal:
You can repeat your call immediately when convinced that no other radio traffic is interfered with.
You can repeat your call after 2 minutes.
You must call on another working channel.
You must call on distress channel.
Distress MF communications should normally be operated:
In G3E mode – on simplex basis.
In J3E mode – on simplex basis.
In J3E mode – on duplex basis.
In G3E mode – on duplex basis.
Which equipment will detect a signal from a SART transponder?
The correct functioning of a DSC-modem can be checked by means of:
The built-in test facility in the modem.
Tester provided with the equipment.
The obligatory monthly transmission from the RCC’s.
The testing-mode of the ever present VHF-DSC-EPIRB.
Which of the following frequency bands would most likely provide reliable communication between two stations that are 15 miles apart?
The Very High Frequency (VHF) band.
The Medium Frequency (MF) band.
The High Frequency (HF) band.
The Low Frequency (LF) band.
Which word will precede an urgency message?
Is it necessary to state the accounting code of the vessel in fully automated radio telex-traffic with a coast-station?
No, when AAIC is unknown, it will be asked for.
No, because the AAIC is included in the radio telex-identification.
It depend upon your location.
According to the rules of GMDSS all vessels have to be equipped with:
A possibility to receive MSI.
At least three mariphones.
The number of oscillations of a wave per seconds is called:
At the end of a radio telex-connection, when a “store and forward” message has been transmitted, the coast-station at least gives a:
Time (in UTC) whereupon the telex for the subscriber is delivered.
Approximate time when telex will be delivered.
Code in letters which will be repeated when the telex has been delivered to the subscriber.
The typical “daylight-frequencies” for long distance transmission are located in the:
Define the class of emission H3E:
Radiotelex and DSC – Frequency shift keying of carrier with error correction.
Radiotelex and DSC – Frequency shift keying of sub-carrier with error correction.
Radiotelephony – Single sideband full carrier.
Radiotelephony – Frequency modulation.
When sending an OBS (weather report) with Inmarsat one should use Service Code “41”. With this address the weather report will always be transmitted to:
The meteorological office of the ship’s flag state.
MET office Washington, this office will take care of further dispatch of the weather reports.
The meteorological station connected with the CES used.
Reflection of radio waves in the ionosphere depends on:
The propagation speed of propagation.
The chosen mode of transmission.
The propagation of radio-signals in the VHF-band is:
Dependent on the hour of transmission (day or night).
Dependent on the power emmited and the temperature of the atmosphere.
You receive a distress alert on HF Radio. What should you do?
Wait three minutes and if no acknowledgement is heard from a coast station you should relay the alert.
Relay the message immediately on 2 182 kHz.
No response is necessary providing the vessel is more than 24 hours away.
The distress message is used when the vessel is threatened by a serious and imminent danger and is in need of immediate assistance. What is the telegraphy and telephony distress message like?
F F F (Telegraphy) / RESCUE-RESCUE (Telephony).
X X X (Telegraphy) / PAN-PAN (Telephony).
T T T (Telegraphy) / SECURITE (Telephony).
S O S (Telegraphy) / MAYDAY (Telephony).
On the MF/HF transmitter-receiver there is a sensitivity control. Another name for this is:
The altitude effect of the reflection of radio waves in the ionosphere on the transmission range also depends on:
The sensitivity of the receiver.
The position of the pre-selector tuning-button.
The ID of an Inmarsat-M station on board starts with:
A DSC distress alert is received. The message states that communication by radiotelex is prefered. One preferably uses:
The compulsory testing of a prescribed EPIRB is to be done:
The effect of reflection of the radio waves in the ionosphere on the range depends on:
The correct adjustment of the dimmer.
The amount of ionisation.
The correct adjustment of the button band width.
The correct adjustment of the clarifier.
With what system is a NAVTEX-message transmitted?
By the term “Stand by” the operator of a coast-station means that one should:
Give the position of the ship.
Wait on this channel for one hour.
Switch back to the calling channel.
Wait until the coast-station calls again.
According to the rules of GMDSS vessels are equipped with certain radio-communication devices depending on:
In maritime communication two international treaties are primarily involved. They are:
SOLAS and the international treaty for messaging.
The IMO at London and the ITU at Geneva.
GMDSS hand book and MERSAR.
In radio-telex distress traffic preference is given to FEC because:
The system automatically requests repetition when reception garbled.
Everybody can read along.
The Satellite orbit in the Cospas-Sarsat system is:
The prescribed periodic tests of the radio set must be entered in:
Manual maritime radio communication.
By FleetNET communication is understood:
An urgent message for all ships in a particular area.
A MSI-message destined for ships in specific geographical area.
A HF-NBDP-message destined for ships in a certain geographical area.
An EGC-message destined for ships with the same group call number.
What are the NAVTEX messages categories which cannot be suppressed?
Sea area A4 is in maritime radio traffic sea area:
Outside the sea areas A1, A2 and A3.
With the exception of sea areas A1, A2 and A3, within the range of Inmarsat-satellites, where continuous alarm is available.
Within VHF-radiotelephony-range of coast station, where continuous DSC-alarm is available.
If messages are received which aren’t intended for own ship:
They must be noted in the radio log book.
They must only be passed to the master.
They must be forwarded to the company.
They must not be used for any purpose.
The display of the DSC-controller on board is showing the following lines: RX: 002442000; CH87; D Sellcall Routine. We’re asked to listen on:
Channel Delta of the coast station.
Radio telephony-channel 7 in the 8 MHz band.
Onboard the following message is received on the DSC controller: DOO: 245329000 CH16; S distress ack 244123000. What station sent the distress acknowledgement?
By wave length is understood:
The distance travelled by a radio vibration in a period.
The propagation direction of a radio vibration.
The length of a single spike in a wave.
The propagation speed of a radio vibration in free space.
The type of Inmarsat station A, B, C, M is recognized by:
The first four digits of the identification.
Last digit of the identification.
The first two digits of the identification.
The first digit of the identification.
A Cospas-Sarsat EPIRB can be used in:
Only in the sea-areas A1, A2 and A3.
Only in the sea-areas A2 and A3.
All sea-areas (A1 to A4).
A distress alert on board may only be transmitted on explicit order of:
The navigating officer on duty.
The whip-antenna of the MF transceiver was lost in bad weather. The MF transceiver can be used again:
If the whip-antenna is replaced by an antenna of about the same length as the original one.
If instead of the whip-antenna, another whip-antenna such as the spare VHF antenna is connected.
Only if the whip-antenna is replaced by another whip-antenna of the same length.
If the whip-antenna is replaced by a Sat-C antenna.
In the Maritime Radio Traffic the order of priority is:
Urgency traffic, distress traffic, safety traffic.
Urgency traffic, safety traffic, routine traffic.
Distress traffic, urgency traffic, safety traffic.
Safety traffic, distress traffic, urgency traffic.
The DSC-controller display the following: DOO: 244562000 CH16; S distress sinking. After receiving this DSC message the following is done immediately:
Give a “DSC-acknowledgement”.
Listen out on VHF channel 16.
Send a “distress alert relay”.
With an Inmarsat-C installation there is the addressing-option “special”. Via this option:
You can send a message by express delivery.
You can deliver a message via a special telegram.
Give one of Inmarsat’s “special access codes”.
You can plan a message to be delivered at a special time.
If requested by a coastal radio station to participate in a rescue operation, what is the most important information you may give?
Your position, name, call sign and speed.
Via Inmarsat-C a message is sent to an Inmarsat-C mailbox with a positive delivery notification (PDN). The ground station will:
Send a PDN, if the message has arrived in the mailbox.
Not send any PDN for this message.
send no PDN’s with messages intended for the mailbox.
Send a PDN, as soon as the message is collected from the mailbox.
A vessel is equipped for all sea areas. In the middle of the Indian Ocean the EGC-receiver appears out of order. Is it still possible to receive MSI-messages?
Yes, with the MF/HF-radio telex.
Give the command after ga + for the transmission of a “store and forward”-message with radio-telex:
Which of the following frequencies is used by the NAVTEX system?
According to the rules of GMDSS vessels one must be able to receive MSI with the aid of:
Emergency portable radio.
Of the AM-signal:
Amplitude and frequency of the carrier wave are constant.
Both amplitude and frequency of the carrier wave are variable.
Is not dependent on the frequency and amplitude.
Amplitude is variable and frequency of the carrier wave is constant.
After confirmation that there is no other radio-traffic, we call on a VHF working channel of a coast-station. When you don’t get any reply:
You can repeat your call immediately.
You must wait 3 minute minimum before repeating your call.
You must wait 5 minutes before repeating the call.
You must wait 1 minute minimum before repeating your call.
Which wave length applies to a frequency of 2 000 kHz?
DSC uses for automatic identification the MMSI. The identification 002442000 is assigned to:
A coast-station or coast guard-station.
To get proper conversation discipline in maritime radio traffic:
Every available VHF-channel should always be used.
Only after permission by captain, to send and/or receive on a VHF-channel pointed out the master.
Communication should be done only as per company’s prescribed schedule.
Only necessary radio conversations are made in a concise and businesslike way.
What do you understand by the initials EPIRB?
This means: Emergency Plotting Indicator Response Beacon.
This means: Emergency Position Indicating Radio Beacon.
This means: Emergency Personal Indicator Rescue Beacon.
This means: Emergency Plotting Indicator Rescue Beacon.
The log-in of an Inmarsat-C installation is important:
To inform the NSC that one is available for messages offered.
To keep watch on Sat-C for safety messages.
To inform the LES, that one is available for messages offered.
To inform the addressee, that one is available for messages offered.