Test results
Command of radio-traffic between vessels and coast stations lies:
Is it necessary to state the accounting code of the vessel in fully automated radio telex-traffic with a coast-station?:
According to the rule of GMDSS, channel 70 is used for:
What are the NAVTEX messages categories which cannot be suppressed?:
By the term “Stand by” the operator of a coast-station means that one should:
The number of oscillations of a wave per seconds is called:
What is the proper term used to describe a coast radio station that primarily handles chargeable ship-to-shore message traffic of a routine nature?:
If requested by a coastal radio station to participate in a rescue operation, what is the most important information you may give?:
On board they want to have a dial-phone call via Inmarsat with the Apollogracht. In the guides the following ID’s are found for the Apollogracht: 344320000, 424432010, 424432020, 1300210, 36715. What ID should be chosen?:
In the Inmarsat Maritime Communications Handbook one can find information about:
MF communication is usually provided by:
Via a coast-station radio medical advice is asked using NBDP. What command has to be given after ga +?:
You wish to send an e-mail using the Inmarsat-C installation. The message has to be composed in:
According to the rules of GMDSS all vessels have to be equipped with:
Is it necessary to state the accounting code of the vessel in fully automated radio telex-traffic with a coast-station?:
The battery of an EPIRB should be changed:
Which of the following services is not provided by Inmarsat-C?:
The different layers in the ionosphere, important for radio propagation, are effected by:
Silencing by a station, not in charge of the distress-traffic, is done as follows:
Automatic amplifier regulation is used for the following reasons:
On area A1 the function “Reception of shore to ship distress alerts” is mainly based on:
The propagation of radio-signals in the VHF-band is:
How will you start a cancelling message after you send by mistake a distress call on your VHF DSC equipment?:
What is the emergency frequency on MF (Medium Frequency) radio?:
The MF/HF-transceiver on board is tuned to the assigned frequency of a station. To make this connection the following mode is used:
What information has to be given to set up a radio telex-connection with a coast-station:
Which word will precede a routine message?:
A distress alert sent by Inmarsat to an RCC is sent via:
Your vessel is not in distress and not taking part in a distress operation. How would you impose radio silence on vessels which are interfering the distress traffic?:
The prescribed test of an approved portable VHF radio set (portophone) must be done once a:
The “clarifier” has only effect during:
What are the NAVTEX messages categories which cannot be suppressed?:
If a ship in the MF-band wants to have a DSC-connection with a coast-station (no “distress alert” or a test alert) the following frequencies are chosen:
Inmarsat is short for:
To receive distress alerting and MSI via an Inmarsat-C set vessels must have:
The exact position of a 406 MHz COSPAS SARSAT EPIRB is eventually calculated by:
In radio-telex distress traffic preference is given to FEC because:
One can check the functioning of the SART by:
The identification of a coast station is composed as follows:
A DSC-notice should be sent on VHF-channel:
Which of the following frequency bands would most likely provide reliable communication between two stations that are 15 miles apart?:
By reduced transmitting power is meant in VHF a power between:
Distress MF communications should normally be operated:
With what system is a NAVTEX-message transmitted?:
The ideal aerial length depends on:
The word SHIP is spelled conform the international phonetic alphabet:
Which of the following is a coast station MMSI?:
In the traffic list a coast-station indicates that there is a radio telex-message for a vessel. To call for the message one should put in:
The effect of reflection of the radio waves in the ionosphere on the range depends on:
The type of Inmarsat station A, B, C, M is recognized by:
In radio telephony what is the “URGENCY CALL” which should be used to indicate that you have a very urgent message to transmit concerning the safety of another vessel or person?:
Which International Convention introduced the GMDSS?:
The Inmarsat-satellites are located:
Which word will precede an urgency message?:
Which word will precede a safety message?:
The typical “daylight-frequencies” for long distance transmission are located in the:
The log-in of an Inmarsat-C installation is important:
The wavelength of a radio-signal reflected against the F-layer may be:
You receive a distress alert on HF Radio. What should you do?:
An area within the radiotelephone coverage of at least one VHF coast station in which continuous DSC alerting is available is called:
The ship-shore HF-telephone-channel 2 228 consists of the frequencies 22 081,0 kHz and 22 777,0 kHz. In case of manual operation, one should tune the receiver on:
With maintenance of batteries it is of primary importance that:
You want to send a DSC-call in connection with a shore telephone-call. You must choose:
Moored in a harbour, transmitting with a mariphone is:
For how long time should a “SARSAT COSPAS” epirb be able to operate on its batteries?:
The batteries must be placed in a well ventilated place, so that:
The impedance of a coax cable for the VHF-set depends on:
To get proper conversation discipline in maritime radio traffic:
The traffic list of a coast-station is a list of:
The effect of reflection of the radio waves in the ionosphere on the range depends on:
When a character in the NAVTEX message sent is not received in the proper way:
What HF-band is generally suitable for long distance transmission if one of two stations is Located in twilight?:
On the MF/HF transmitter-receiver there is a sensitivity control. Another name for this is:
What is understood by carrier frequency?:
The MERSAR is:
What does the abbreviation VHF means?:
The squelch on the control panel of a VHF-sat serves to:
The number of oscillations of a wave per seconds is called:
The safety message announces that a station:
By frequency is meant: